Damit Dam Sealer

DO YOU HAVE A PROBLEM WITH A LEAKING DAM OR POND?

  • Fix your leaking dam with DamIt
  • Apply directly to the water surface
  • No need to drain water or empty the dam
  • No need for expensive earth moving equipment
  • Fix it yourself as DamIt creates a permanent seal

DamIt™ Dam Sealer is an advanced, non-toxic, polymer powder which can be used to seal leaking dams and ponds. The polymer is applied to a leaking dam or pond by scattering the powder across the surface of the water.

DamIt™ Dam Sealer is designed with a positive charge which draws it downward through the water toward the bottom of the dam or pond. The water pressure (hydrostatic pressure), which causes the dam or pond to leak, forces the polymer down into cracks and crevices as it sinks to the bottom of the pond or dam.

Once activated with water, the polymer will expand in size and bind to other polymer particles to form larger groups of particles, which effectively slows and stops the leak. The polymer will continue to expand over several hours and forms a flexible plug that withstands water pressure.

The positive charge of the particles will also attract any silt and suspended matter in the water downward to the bottom, which acts to embed the polymer within the soil structure and minimise any disturbance or movement of the polymer that may be caused by future water inflows.

DamIt™ Dam Sealer is insoluble and will form a long-term plug, in cracks and porous soils. The polymer stays active when wet and can withstand continuous wet/dry cycles to accommodate rising and falling water levels due to seasonal water level variations in the dam or pond.

DamIt™ Dam Sealer is a rapid, cost effective solution for sealing water leaks and does not require earthmoving equipment or the emptying of dams and ponds; allowing you to save valuable water and keep the dam or pond in use while repairs are undertaken.

DamIt™ Dam Sealer works on a wide range of soil types; from clays to sandy loams and in a wide range of water types; from clear, pure drinking water through to saline water with high levels of suspended clays typically found in rural stock dams.

Sealit Multipurpose Sealer

ACRYLIC CLEAR, WATERPROOFING COMPOUND

Shalex SealIt Multipurpose is a water based general purpose clear waterproofing compound designed for use on a wide variety of substrates.

SealIt Multipurpose is especially suited to sealing and protecting porous vertical masonry surfaces such as split faced or decorative concrete blocks.

SealIt is particularly effective against wind driven rain and unlike ‘water repellent’ style sealers, can withstand hydrostatic pressures caused by significant weather events.

SealIt is UV stable and provides long term protection, for example 10 years or more.

SealIt Multipurpose dries to a clear low sheen finish and remains flexible to accommodate minor movement in the substrate.

SealIt can be over painted with any acrylic paint.

Due to exceptional adhesion SealIt is well suited as a primer for acrylic architectural topcoats, elastomerics and roofing paints.

As SealIt is a very soft sealer it is not suitable for use on horizontal surfaces that are subject to traffic (e.g. paths, pavers, floors etc) unless they are to be covered with tiles, carpet, or harder coatings.

With difficult to wet out surfaces, hot surfaces, or in very hot and windy conditions, the application of a very fine mist spray of water over the surface may help absorption prior to application of the primer coat. The surface should be just damp, not wet. Place drop sheets down on floor surfaces to ensure no run-off or drips occur when applying SealIt Multipurpose to walls.

Stickit Pro

FIX LOOSE OR DRUMMY TILES

Repairing loose tiles used to mean pulling them all up and re-laying them which can cost thousands of dollars.

Not any more!

The StickIt Pro Epoxy Tile Injection Repair Kit is so easy to use, almost anyone with a drill can do it.

StickIt Pro is a new generation epoxy adhesive specifically designed to fix loose or drummy tiles without having to pull them up.

StickIt Pro will also fix drummy render and will save you time, money and inconvenience.

StickIt Pro can be used to fix a range of issues like:

Drummy or delaminated floor and wall tiles

Fill voids or gaps
Rebond loose laminates
Creaking wood floors
Timber joint or crack adhesive
Reinforce cement render or plaster
Rebond carpets and fabrics

Shopping Basket
Verified by MonsterInsights